Planet Technology IP DSLAM IDL-4801 - Manual (Page 81)

IP DSLAM 81
4.1.4 Line Rate Configuration
This section describes how to configure the transmission rate manually via CLI. Before
configuration, see follows.
1. Input the line rate by using hexadecimal values. Following tables shows the
hexadecimal values that are frequently used.
Hexadecimal 0x1f38300 0x177000 0x109a00 0x7d000 0x1f400 0xfa00 0x7d00
Decimal 32M 1.5M 1M 512K 128K 64K 32K
2. Be noted that GsStandard, GsTxPowerAtten and GsAnnexType must be modified
at the same time.
3. Frequently used commands are listed below for your reference:
z aturintlmaxtxrate 0x7d000 atucgsannextype adsl2 atucgsstandard adsl2plus
atucgstxpoweratten 0 atucmaxintldelay 1
z atucfastmintxrate 0xfa00 aturfastmintxrate 0x7d00 atucgsannextype annexa
atucgsstandard glite atucgstxpoweratten 0 type fastonly atucrateadaptation fixed
RATE type Standard Annex type
ATUC Fixed/ Adaptive Interleaved / fast
only
Adsl2+ / G.dmt /
G.lite / T1.413
Adsl2 / annex A
ATUR Fixed/ Adaptive Interleaved / fast
only
Adsl2+ / G.dmt /
G.lite / T1.413
Adsl2 / annex A