Planet Technology IP DSLAM IDL-4801 - Manual (Page 480)

IDL series User Guide 480
Type: Create － Optional
Modify － Optional
Default value:enable
enable|disable Administrative Status of the interface.
Type: Optional
Valid values: enable or disable
Example:
$ create ipoe intf ifname Ipoe-0 lowif Ipoa-0 macaddrprof 1 ethpkttype Type2
inactivitytmrintrvl 10 routingstatus disable cfgmode Auto enable
Output:
Verbose Mode On
Entry Created
Ifname : Ipoe-0 Low If Name : Ipoa-0
Mac Addr Prof : 1 Eth Pkt Type : Type2
InActivity Tmr Interval : 10
RoutingStatus : disable
Oper Status : Up Admin Status : Enable
Verbose Mode Off:
Entry Created
Output Fields:
FIELD Description
Ifname The IPOE Tunneling Interface.
Low If Name This specifies the lower interface index.It contains the
ifindex of the IPoA interface.
Mac Addr Prof Profile Id corresponding to the MAC address assigned to
this IPOE interface. This Profile is created using the
MacAddrProfileTable.
Eth Pkt Type This specifies the type of the Packet.
InActivity Tmr Interval This field specifies the time (in seconds) after which
interfaces shall be marked inactive, if there is no data
activity on this interface during this interval. This is used
only when the bit corresponding to "ConfigEntry" is set for
gsvIpoeConfigStatus field. A value of zero means the timer
is not running. In autosensing scenario, an inactive
interface is a candidate to deletion, if another protocol is
sensed on Atm Vc Interface on which this interface is
created