Planet Technology IP DSLAM IDL-4801 - Manual (Page 385)

IP DSLAM 385
Optional
Modify － Optional
Default value: "\0"
priority <priority-val> Priority to be set for packets matching this rule. This field is valid
only if RuleAction is 'setprio' or 'retagprio'. If the RuleAction is
'setprio' then this value is internal priroity and is used along with
egress port traffic class mapping table, to determine the output
queue. If the RuleAction is 'retagprio' then this value is priority which
is to be tagged into the outgoing packet and it is also used along with
egress port traffic class mapping table, to determine the output
queue. This field can be modified only if 'status' has the value
'disable'.
Type: Create － Optional
Modify － Optional
Valid values: 0 - 7
Default value: 0
status enable | disable Admin status of the rule
Type: Create － Optional
Modify － Optional
Default value: disable
statsstatus enable
|disable
Admin status of rule statistics. Statitics of a rule are collected only
when this field is set to 'enable'. This field can be modified only if
'status' has the value 'disable'. NOTE - Statistics may not reflect
correctly the number of egress mcast, bcast and unknown unicast
packets hitting the rule.
Type: Create － Optional
Modify － Optional
Default value: disable
ruleprio low | high Tells the priority of the rule. Based on this priority value, the rule is
created in fast or slow memory. This field can be modified only if
'status' has the value 'disable'. This field is ignored if the 'ruleAction'
has value 'clfrdef'
Type: Create － Optional
Modify － Optional
Default value: high
ruledir in | out Specifies whether the rule will be applied on incoming interfaces
(ingress)or outgoing interfaces(egress).
Type: Create － Optional
Default value: in