Planet Technology IP DSLAM IDL-4801 - Manual (Page 290)

IDL series User Guide 290
atucconfmininp Inp0 |
InpPoint5 | Inp1 | Inp2 |
InpAuto | Inp4 | Inp8 | Inp16
Parameter used to specify the minimum impulse noise protection for
the downstream bearer channel.
Type: Modify -- Optional
atucpml2entrythreshrate
<atucpml2entrythreshrate-val
>
PM config param. L2 state entry data rate.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
atucpml2exitthreshrate
<atucpml2exitthreshrate-val>
PM config param. L2 state exit data rate.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
atucpml2entryratemintime
<atucpml2entryratemintime-v
al>
PM config param.Min L2 entry rate time
Type: Modify -- Optional
Valid values: 900 - 65535
atucgscabinethsenable
Disable | Enable
Enable/Disable HS tones in Cabinet mode
Type: Modify -- Optional
atucgsseltlooptype
RealCable | Dls90 | Dls400
Conexant parameter that is used to specify the loop type for SELT. The
default value mentioned is an indicative value only.
Type: Modify -- Optional
atucgsrxstartbinu1
<atucgsrxstartbinu1-val>
Conexant parameter that specifies lowest bin number allowed for Rx
signal in G.Span Plus SUQ mode. By selecting the receive start and
end bin numbers, the user can limit the bins for special
configurations.(length = 4 bytes)
Type: Modify -- Optional
atucgsrxendbinu1
<atucgsrxendbinu1-val>
Conexant parameter that specifies highest bin number allowed for Rx
signal in G.Span Plus SUQ mode. By selecting the receive start and
end bin numbers, the user can limit the bins for special
configurations.(length = 4 bytes)
Type: Modify -- Optional
gspsdmaskdsenable
PsdMaskDisable |
PsdMaskEnable |
PsdMaskEnableMod
Conexant parameter that is used to configure the switching point
between DBM-OL and XOL.(length = 4 bytes)
Type: Modify -- Optional
gspsdmaskusenable
PsdMaskDisable |
PsdMaskEnable |
PsdMaskEnableMod
Conexant parameter used to enable the Mask on Demand(MoD)
feature in the upstream direction. It is available only for ADSL2 Annex A
ONLY.(length = 4 bytes)
Type: Modify -- Optional
psdmaskdsfallbackenable
False | True
Conexant parameter used to enable Mask on Demand (MoD) fallback
mode. When enabled, the system chooses MoD or the base ADSL2
depending upon the downstream rate. It is avaiable only for ADSL2
Annex A.(length = 4 bytes)
Type: Modify -- Optional