Planet Technology IP DSLAM IDL-4801 - Manual (Page 291)

IP DSLAM 291
Valid values: False, True
psdmaskusfallbackenable
False | True
Conexant parameter used to enable Mask on Demand (MoD) fallback
mode. When enabled, the system chooses MoD or the base ADSL2
depending upon the upstream rate. It is avaiable only for ADSL2 Annex
A.(length = 4 bytes)
Type: Modify -- Optional
Valid values: False, True
atucconfmaxnompsdds
<atucconfmaxnompsdds-val>
This parameter specifies the maximum nominal transmit
PSD(MAXNOMPSD) level during initialization and showtime. Value
depends on CO MIB element settings and near end transmitter
capabilities and is exchanged in the G.994.1 Phase. It is available only
for ADSL2/ADSL2plus. Value ranges from -60 to -40 in steps of 0.1
dBm/Hz.(length = 4 bytes)
Type: Modify -- Optional
Valid values: (-600) - (-400)
aturconfmaxnompsdus
<aturconfmaxnompsdus-val>
This parameter specifies the maximum nominal transmit
PSD(MAXNOMPSD) level during initialization and showtime. Value
depends on CO MIB element settings and near end transmitter
capabilities and is exchanged in the G.994.1 Phase. It is available only
for ADSL2/ADSL2plus. Value ranges from -60 to -38 in steps of 0.1
dBm/Hz.(length = 4 bytes)
Type: Modify -- Optional
Valid values: (-600) - (-380)
atucconfmaxnomatpds
<atucconfmaxnomatpds-val>
This parameter specifies the maximum nominal aggregate transmit
power(MAXNOMATP) level during initialization and showtime. Value
depends on CO MIB element settings and local capabilities and is
exchanged in the G.994.1 Phase. It is available only for
ADSL2/ADSL2plus. Value ranges from 0 to 25.5 in steps of 0.1
dBm.(length = 4 bytes)
Type: Modify -- Optional
Valid values: 0 - 255
aturconfmaxnomatpus
<aturconfmaxnomatpus-val>
This parameter specifies the maximum nominal aggregate transmit
power(MAXNOMATP) level during initialization and showtime. Value
depends on CO MIB element settings and local capabilities and is
exchanged in the G.994.1 Phase. It is available only for
ADSL2/ADSL2plus. Value ranges from 0 to 25.5 in steps of 0.1
dBm.(length = 4 bytes)
Type: Modify -- Optional
Valid values: 0 - 255
atucconfpsdmaskds This configuration parameter defines that the downstream PSD mask