Planet Technology IP DSLAM IDL-4801 - Manual (Page 502)

IDL series User Guide 502
5.19.5.2 Create pppoe intf
Description:
Use this command to create.
Command Syntax:
create pppoe intf ifname <interface-name> lowif <lowif –val>[ wanbridgeport
<wanbridgepor-val>t ] [sessionid <sessionid-val> ] [ acmacaddr
<acmacaddr-val> ] macaddrprof <macaddrprof-val> [ servicenameprof
<servicenameprof-val> | any | anyconfigured ] [ acnameprof <acnameprof-val> |
any | anyconfigured ] [ ethpkttype Type2 | 802_3 ] [ nature dynamic | static ]
[ enable | disable ]
5.19.5.3 Delete pppoe intf
Description:
Use this command to delete.
Command Syntax:
delete pppoe intf ifname <interface-name>
5.19.5.4 Modify pppoe intf
Description:
Use this command to modify.
Command Syntax:
modify pppoe intf ifname <interface-name> lowif <lowif –val>[ wanbridgeport
<wanbridgepor-val>t ] [sessionid <sessionid-val> ] [ acmacaddr
<acmacaddr-val> ] macaddrprof <macaddrprof-val> [ servicenameprof
<servicenameprof-val> | any | anyconfigured ] [ acnameprof <acnameprof-val> |
any | anyconfigured ] [ ethpkttype Type2 | 802_3 ] [ nature dynamic | static ]
[ enable | disable ]
Parameters:
Name Description
lowif <lowif-val> This specifies the lower interface index. It contains the ifindex of the
PPP relay interface.
Type: Create － Mandatory
Valid values: 0 - 254
wanbridgeport
<wanbridgeport-val>
WAN side bridge port. A value of zero means any WAN side port is
acceptable. Currently, only value zero is supported.