Planet Technology IP DSLAM IDL-4801 - Manual (Page 509)

IP DSLAM 509
Parameters:
Name Description
ifname
<interface-name>
The PPPR interface.
Type: Create － Mandatory
Delete － Mandatory
Modify － Mandatory
Get － Optional
Valid values: 0 － 254
lowif <lowif-val> This specifies the name of the lower AAL5
interface.
Type: Create －Mandatory
Valid values: 0 - 574
maxpdu <maxpdu-val> This specifies the maximum PDU size on a PPPR
interface.
Type: Create － Optional
Valid values: 0 - 1492
Default value: 1492
ppprackto
<ppprackto-val>
Time in seconds to wait for LCP terminate Ack,
after sending a terminate request.
Type: Create － Optional
Modify － Optional
Valid values: 0 -10
Default value: 5
lowiftoggletimerto
<lowiftoggletimerto-val>
Time in seconds to wait for lowif to come up
without tearing down the pppr session.
Type: Create － Optional
Modify － Optional
Valid values: 0 – 10
Default value: 5
nature dynamic |
static
Specifies if the interface is dynamic or static in
nature.
Type: Create － Optional
Modify － Optional
Default value: Dynamic
configstatus Normal
|Config
This mode describes the configuration status for
the interface. If the "config" bit is set, this interface
shall be created, but will have a dormant status.
Only after the receipt of an pppoa packet from the
CPE side, this interface shall become active.
Type: Create － Optional