Planet Technology IP DSLAM IDL-4801 - Manual (Page 182)

IDL series User Guide 182
Output Fields:
Field Description
PortId This is the bridge port identifier. It can be : 1- 386
Max Info Size The maximum size of the INFO (non-MAC) field that this port will
receive or transmit.
Out Frames The number of frames that have been transmitted by this port to its
segment.
In Frames The number of frames that have been received by this port from its
segment.
In Discards Count of valid frames received, which were discarded (i.e., filtered)
by the Forwarding Process.
HC In Frames Number of frames that have been received by this port from its
segment. This is valid only for Ethernet interfaces.
HC Out Frames Number of frames that have been transmitted by this port to its
segment. This is valid only for Ethernet interfaces.
HC In Discards Count of valid frames received and discarded (i.e filtered) by the
Forwarding Process. This is valid only for Ethernet interfaces.
5.6.7 Bridge Port Table Commands
5.6.7.1 Create bridge port intf
Description:
Use this command to create a new bridge port.
Command Syntax:
create bridge port intf portid <portid-val> ifname <interface-name> [maxucast
<max-ucast-addresses> ] [learning enable|disable][status enable|disable]
[stickystatus enable | disable] [FdbModify enable | disable][ aclglbdenyapply
Enable | Disable ] [ aclglbtrackapply Enable | Disable ] [ proxyarpstatus enable |
disable ] [ arptstatus Enable | Disable ] [ darpstatus Enable | Disable ] [ porttype
trusted | untrusted ]
5.6.7.2 Delete bridge port intf
Description:
This command is used to delete an existing bridge port.
Command Syntax:
delete bridge port intf portid <portid-val>