Planet Technology IP DSLAM IDL-4801 - Manual (Page 210)

IDL series User Guide 210
5.7 Bridge Multicast Commands
5.7.1 Bridge mcast forwarding Commands
5.7.1.1 Get bridge mcast forwarding
Description:
Use this command to get.
Command Syntax:
get bridge mcast fwdall [vlanid <vlanid-val>]
5.7.1.2 Modify bridge mcast fwdall
Description:
Use this command to modify.
Command Syntax:
modify bridge mcast fwdall [vlanid <vlanid-val>] [egressports
<egressports-val> | none] [forbidegressports <forbidegressports-val> | none]
Parameters:
Name Description
vlanid <vlanid-val> The VLAN id for this VLAN. In devices supporting "Shared Vlan
for multicast" capability, the information for a multicast MAC
address is shared across vlans. Hence vlan id is an optional
parameter. In devices supporting "Independent Vlan for
multicast" capability, each vlan can have its own information for
a multicast MAC address. Hence vlanid is a mandatory
parameter in all the commands other than - get. For No Vlan
case, vlan id is not required. VLAN here means the 802.1q Vlan
in case of Native Vlan mode and Virtual Vlan in case of Stacked
Vlan Mode.
Type: Get － Optional
Valid values: 0 - 4095
egressports
<egressports-val> | none
The set of ports, configured by management in this VLAN, to
which all multicast group-addressed frames are to be
forwarded. More than one value can be given, separated by
spaces.
Type: Modify -- Optional
Valid values: 0
forbidegressports The set of ports configured by management in this VLAN, for