Planet Technology IP DSLAM IDL-4801 - Manual (Page 505)

IP DSLAM 505
Session Id Session Id for the session given only in case a static
session is being created.
AC Mac Addr MAC address of the remote AC given only in case a static
session is being created.
Mac Addr Prof Profile Id for self MAC addresses. The profile for the same
is created using the PPPoEMacAddrProfileTable.
Service Name Profile Profile Id related to Service Name for the Session based on
which the AC is selected.The Profile for the same is
created using the PPPoESessionProfileTable. A value of
"any" means no specific service is needed to select an AC.
A value of "anyconfigured"means any configured service
name profile can be used for selecting an AC.
AC Name Prof Profile Id related to AC Name for the Session based on
which the AC is selected. The Profile for the same is
created using the PPPoEAcProfileTable. A value of "any"
means no specific AC is needed for establishing a session
on the WAN side. A value of "anyconfigured"means any
configured AC name profile can be used for selecting an
AC.
Eth Pkt Type This specifies the type of the packet.
Nature Specifies if the interface is dynamic or static in nature. The
session is assumed to be in established state when the
interface is static in nature.
Oper Status The actual/current state of the interface. It can be either up
or down.
Admin Status The desired state of the interface. It may be either Up or
Down.
References:
z
PPPoE session config related commands.