Planet Technology IP DSLAM IDL-4801 - Manual (Page 471)

IP DSLAM 471
the system and each RID defines separate routes in context
of itself. . If VlanId <X> and RID <X> have been created and
the routing database is configured for IRD, than routes in RID
<X> shall define flow for packets coming on VLAN Id <X>.
The other mode for the database is SRD( Shared Routing
Database) where there is a single RID in the system and all
flows map to this RID. This RID has to be explicitly created
and no more than one RID can be created in the system in
this mode. Flows for all created VLANs shall map to this RID
for routing.
Ifname This specifies the physical interface for the media. It
indicates the interface over which the IP address for which
the IP Net to media mapping has been created can be
reached.
Ip Address. IP address corresponding to the media-dependent physical
address.
Type This defines the type of mapping in use. The value Invalid
has the effect that this entry is not used. It may be: Static,
Dynamic, Other
Mac Address The media-dependent physical address
Cautions:
z The specified interface should pre-exist. Please refer to the create ethernetintf
command.
References:
z delete arp command
z get arp command
z create ethernet intf command
z ip route related commands
5.16.2 IP Route Commands
5.16.2.1 Get ip route
Description:Use this command to get.
Command Syntax:
get ip route [rid <rid-val>] ip <dest-ip-address> mask <net-mask>