Planet Technology IP DSLAM IDL-4801 - Manual (Page 477)

IP DSLAM 477
enable|disable Administrative status of the interface.
Type: Optional
Valid values: enable or disable
Example:
$ create ipoa intf ifname Ipoa-0 lowif aal5-0 configstatus Normal enable
Output:
Verbose Mode On
Entry Created
Ifname : Ipoa-0 Low IfName : aal5-0
Config Status : Normal
Oper Status : Up Admin Status : Enable
Verbose Mode Off:
Entry Created
Output Fields:
FIELD Description
Ifname The Ipoa Interface
Low IfName This specifies the name of the lower AAL5
interface.
Config Status This mode describes the configuration status for
this interface. If the "config" bit is set then this
interface shall be created but will have a dormant
status. Only after the receipt of an Ipoa packet
from CPE side this interface shall become active.
The "In-Use" and "Not-In-Use" bits are read only
bits. The "Not-In-Use" indicates that the entry is
dormant and "In-Use" indicates that the entry is
activated.
Admin Status Administrative status of the interface.
Oper Status Operational status of the interface.