Planet Technology IP DSLAM IDL-4801 - Manual (Page 623)

IP DSLAM 623
recommended to keep the value for this different from
ProtocolId value defined for 802.1q Vlan(0x8100). This
attribute is applicable only in 'VLAN Stacking mode'.
Type: Modify － Optional
Valid values: 0x8100 - 0xFFFF
tvlanprotocolid
<tvlanprotocolid-val>
This specifies the ProtocolId value to be used for Stacked
Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is
recommended to keep the value for this different from
ProtocolId value defined for 802.1q Vlan (0x8100). This
attribute is applicable only in 'VLAN Stacking mode'.
Type: Modify － Optional
Valid values: 0x8100 － 0xFFFF
tvlanid <tvlanid-val> This specifies the ProtocolId value to be used for Stacked
Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is
recommended to keep the value for this different from
ProtocolId value defined for 802.1q Vlan(0x8100). This
attribute is applicable only in 'VLAN Stacking mode'.
Type: Modify － Optional
Valid values: 0 - 4095
abondglbctrlvpi
<abondglbctrlvpi-val>
This VPI value will be used for the control channel which will
be created to run the ATM based multi pair bonding
protocol. This is a system wide parameter and applies to all
the abond group interfaces which can be created in the
system. Change in this value will be applied at next boot
only.
Type: Modify － Optional
abondglbctrlvci
<abondglbctrlvci-val>
This VCI value will be used for the control channel which will
be created to run the ATM based multi pair bonding
protocol. This is a system wide parameter and applies to all
the abond group interfaces which can be created in the
system. Change in this value will be applied at next boot
only.
Type: Modify － Optional
abondglbsidfmt
EightBitSid |
TwelveBitSid
This SID Format value will be used for all the Abond Group
Interfaces which can be created in the system. Change in
this value will be applied at next boot only.
Type: Modify － Optional
Example:
$ get nbsize