Planet Technology IP DSLAM IDL-4801 - Manual (Page 163)

IP DSLAM 163
if any ATM VC is created on top of this ATM port.
Mirror Mode This field configures ATM port in data mode or mirror mode. In mirror mode,
only the mirrored packets are allowed to go out of the port and regular
customer data is forbidden. Scheduling profile field is ignored in mirror mode.
Oper Status The actual/current state of the interface. It can be either up or down.
Admin Status The desired state of the interface. It may be either Up or Down.
5.5.5 ATM VC Commands
5.5.5.1 Create atm vc intf
Description:
Use this command to create a new ATM Virtual Circuit (VC).
Command Syntax :
create atm vc intf ifname <interface-name> vpi <vpi-val> vci <vci-val> lowif
<atm-port-interface-name> [enable | disable] [aal5] [a5txsize
<aal5-cpcs-tx-sdu-size>] [a5rxsize <aal5-cpcs-rx-sdu-size>] [vcmux | llcmux | auto
| ethernet] [pvc] [channel fast|interleaved] [ mgmtmode
data|mgmt|DataAndMgmt| raw] [ maxnumproto <maxnumproto-val> ]
[ autostatus Enable|Disable ] [ autosupportedprot none|{pppoa | eoa | ipoa}+]
[ autovcmuxforcedprot None | pppoa | eoa | ipoa] [ autosensetriggertype
dynamic | opstatechange ] [ ctlpktgroupid <ctlpktgroupid> | none ]
5.5.5.2 Delete atm vc intf
Description:
Use this command to delete an existing ATM Virtual Circuit (VC).
Command Syntax:
delete atm vc intf ifname <interface-name>
5.5.5.3 Get atm vc intf
Description:
Use this command to display information corresponding to a single VC, or for all
VCs.
Command Syntax: get atm vc intf [ifname <interface-name>]