Planet Technology IP DSLAM IDL-4801 - Manual (Page 252)

IDL series User Guide 252
ModPhase Conexant parameter to monitor the status of MoD
Atuc TSSpsUs This parameter provides the Upstream Transmit Spectrum
Shaping parameter expressed as the set of break points
exchanged during G994.1. Each breakpoint consists in a
subcarrier index and the associated shaping parameter.
Value of this parameter is in range 0 - 127, in multiples of
-0.5 dB. 127 is a special value indicating the subcarrier is
not transmitted. It is available only for ADSL2/ADSL2plus.
GainspsUs This parameter defines the upstream gains allocation table
per subcarrier. It is an array of integer values in the 0 to
4093 range for subcarriers 0 to NSCus-1. The gain value
is represented as a multiple of 1/512 on linear scale. It is
supported for ADSL2/ADSl2plus only.
GsSeltInfoValid Indicates the information validity for the SELT operation
conducted on the Xcvr.
GsSeltLoopLen (in Feet) Indicates the LOOP Length in Feet once when the SELT
information is valid on the Xcvr.
GsSeltLoopEnd Indicates whether the loop is short or open once when the
SELT information is valid on the Xcvr.
GsSeltLoopGauge Indicates the LOOP wire gauge information once, when
the SELT information is valid on the Xcvr.
GsSeltUpShannonCap (in bps) Indicates the upstream shannon capacity once, when the
SELT information is valid on the Xcvr.
GsSeltDownShannonCap (in bps) Indicates the downstream shannon capacity once, when
the SELT information is valid on the Xcvr.
AtucGsSeltInbandNoise 512 values that indicate inband noise length in dBM/Hz,
covering both bands from 0 to 1.1 MHz.
AtucGsSeltTerminationResp 180 discrete values that indicate termination response
magnitude from 0 to 18Kft.
AtucGsSeltUpMgnAtRate 300 values that indicate SNR margin in dB/10 at a
particular rate are provided, at 100K increments, up to 15
Mbps.
AtucGsSeltDownMgnAtRate 300 values that indicate SNR margin in dB/10 at a
particular rate are provided, at 100K increments, up to 15
Mbps.
Delt HLINSCus The DELT-related parameter that provides the scale factor
to be applied to the upstream Hlin (f) values. (Not available
for ADSL and ADSL2plus)
Delt HLOGMTus The DELT-related parameter that provides the number of
symbols used to measure the upstream Hlog (f). (Not