Planet Technology IP DSLAM IDL-4801 - Manual (Page 168)

IDL series User Guide 168
VC Type : PVC VC Topology : Point to Point
Max simultaneous protocol : 1
Auto Status : Disable
Auto Supported Protocol : pppoa eoa
Auto VC Mux Forced Protocol : None
Auto Sense Trigger Type : dynamic
Auto Curr Sensed Encaps Typee : none
Ctl Pkts Group Id : none
Auto Supported Protocol : pppoa eoa
Output Fields:
Field Description
VC IfName VC Interface Name. It can be : aal5-0 - *
Low IfName Interface Index of the ATM port, on which this VC is getting configured.
VPI Virtual Path Identifier. In order to modify, the VPI value shall be the new
VPI value and the admin status of VC interface shall be disabled. Also, the
VPI and VCI value cannot be modified along with admin status in one
command. If encaptype is Ethernet than value of this field has to be 0.
VCI Virtual Circuit Identifier. In order to modify, the VCI value shall be the new
VCI value and the admin status of VC interface shall be disabled. Also, the
VPI and VCI value cannot be modified along with admin status in one
command. If encaptype is Ethernet than value of this field has to be 0.
Oper Status This specifies the actual/current state of the interface. It can be either Up
or Down
Admin Status This specifies the desired state of the interface. It may be either Up/Down.
Aal5 Tx Size This specifies the transmit CPCS SDU size to be used.
Aal5 Rx Size This specifies the receive CPCS SDU size to be used.
Aal Type This specifies the AAL type in use for this VC. The only type of AAL
supported in Columbia Packet is AAL5. This field is not valid for an ATM
VC with encaptype as Ethernet.
Aal5 Encap This specifies the data encapsulation method to be used over the AAL5
SSCS layer. "auto" means autosense the muxType(llc/vc). Auto mode is
only used to sense the llc/vcmux . Atm VC with encaptype as ethernet can
be created only over an ATM port which has value of atmtransporttype as
packet.The VPI/VCI values for this atm vc shall be 0/0. aaltype,
mgmtmode and oam related parameters are not valid for an ATM VC with
encaptype as Ethernet.
channel This extension specifies the type of channel on which the ATM VC's cells
have to be transmitted/received. This field is deprecated and currently
not in use.