Planet Technology IP DSLAM IDL-4801 - Manual (Page 323)

IP DSLAM 323
mgmtsvlanid This parameter specifies the S-VLAN for management traffic on this
interface. It is applicable only in stacked-VLAN Mode. Non-zero value of
this field is valid only if either 'etherIfIpAddress' field is non-zero or
'etherUseDhcp' field is true. If no management S-Vlan id is specified (in
the create operation) or its value is set to zero (either in create or modify
operation), then the system shall use the value of 'psvlanid' associated
with the bridge port created on this interface as the management VLAN
id. In case the management VLAN (virtual VLAN mapped to S-VLAN and
C-VLAN for the frame) does not exist (ie. Virtual VLAN mapped to
'mgmtsvlanid' or the associated 'psvlanid', if 'mgmtsvlanid' is zero) on the
system, then IP-based management shall not happen on the interface till
the corresponding virtual-VLAN is created with the Net-side port as its
member.
Type : Create - optional
Modify - optional
Valid values: 0 - 4095
m2vmacdbid This field specifies the M2VMac Database Id associated with this
interface. The value 0 means Virtual MAC feature is disabled on this
interface. This field can be modified only when the interface is disabled.
Type: Create - optional
Modify - optional
Valid values: 1 -GS_CFG_MAX_M2VMAC_DATABASES
mgmttvlanid
<mgmttvlanid-val>
This specifies the value to be used for inserting TVLAN id or vlan id of
the third Vlan tag in the transmitted Ethernet frames and that is expected
in received frames over this interface. Currently this is configurable and
supported only for management Ethernet interface. For data Ethernet
interface, the value of TVLAN id is configurable and used from the
system sizing table. If the value for TVLAN id configured on a
management Ethernet interface is zero then third vlan tag shall not be
added neither shall it be supported in received frames. This attribute is
applicable only in stacked-VLAN mode.
Type: Create -- Optional
Modify -- Optional
Valid values: 0 - 4095
Default value: 0
Example:
create ethernet intf ifname eth-0 ip 192.168.1.1 mask 255.255.255.0 speed 100bt
profilename sprofile mgmtvlanid 2 priority 2 trfclassprofileid 1 Ctlpktinstid 1
ctlpktgroupid 1