Planet Technology IP DSLAM IDL-4801 - Manual (Page 174)

IDL series User Guide 174
Example:
$ get bridge forwarding vlanid 10 macaddr 02:2e:22:3d:44:56
Output:
MAC Addr PortId VlanId Status
-----------------------------------------------------------
02:2e:22:3d:44:56 10 10 learned
Output Fields:
Field Description
MAC Addr A unicast MAC address for which the bridge has forwarding and/or filtering
information. In the case of "delete all" entries in a given FDB; the MacAddr shall
have INVALID value specified by FF: FF: FF: FF: FF: FF. To delete an individual
entry, valid value of Mac address has to be specified.
VlanId Vlan Id to uniquely identify the entry for which the bridge has forwarding and/or
filtering information. To delete an individual learnt entry or all learnt entries, the
FdbId should be set to a valid value in case of IVL. In SVL case, this value is
ignored except when the value is 4097 which is the value of a special Vlan Id used
for managing the traffic for those VLANs that are neither created nor learnt in the
system. When Vlan transparency feature is supported, the valid range for this also
includes 4097. VLAN here means the 802.1q Vlan in case of Native Vlan mode and
Virtual Vlan in case of Stacked Vlan Mode.
PortId Port number of the port on which a frame having a source address equal to the
value of the corresponding instance of dot1qTpFdbAddress, has been seen. This
may have a value of "0" if the statically configured address has a dynamic port
binding and the port has not been learnt yet.
Status The status of this entry. The value learned (3), indicates that the value of the
corresponding instance of dot1qTpFdbPort was learned, and is being used. mgmt
(5) - the value of the corresponding instance of dot1qTpFdbAddress is also the
value of an existing instance of dot1qStaticAddress. The value internal (6) indicates
that the entry is an internal entry and cannot be deleted by the user. This entry gets
created for the IPOE/PPPOE interfaces when the bridge port over those
IPOE/PPOE interfaces gets admin enabled. The mac address in this entry shall be
the one specified in the mac address profile and VlanId shall be the PortVlanId of
the Bridge Port.The value other (1) indicates that this is associated with a sticky
port.