Planet Technology IP DSLAM IDL-4801 - Manual (Page 331)

IP DSLAM 331
be set to true only if encaptype of the lower interface is
Ethernet.
Pkt Type This parameter defines the packet type supported by the
interface. ‘EoAPktTypeSupported’ shall be configured
for every CPE side Ethernet interface. By default, the
option taken is 'ALL' and it means that all packets will be
transmitted. The value 'None' means that normal Ucast
packets will be transmitted. The interface shall not
transmit any other packet type than the ones configured.
Admin Status The desired state of the interface. It may be either Up or
Down
Oper Status The actual/current state of the interface. It can be either
up or down.
InActivity Tmr Interval This field specifies the time (in seconds) after which
interfaces shall be marked inactive if there is no data
activity on this interface during this interval. This is used
only when the bit corresponding to "ConfigEntry" is set
for gsvEoaConfigStatus field. A value of zero means the
timer is not running. In Aautosensing scenario, an
inactive interface is a candidate to deletion in case
another protocol is sensed on Atm Vc Interface on which
this interface is created.
Config Status This parameter describes the configuration mode for this
interface.The value of this parameter can be Normal,
Config, NotInUse, or InUse. If the value is Config, then
this interface shall be created, but will have a dormant
status. Only after the receipt of an EoA packet from the
CPE side, this interface shall become active. The 'InUse'
and 'NotInUse' bits are read-only bits. The 'NotInUse' bit
indicates that the entry is dormant and the 'InUse' bit
indicates that the entry is activated.
M2VMac Database Id This field specifies the M2VMac Database Id associated
with this interface. The value 0 means Virtual MAC
feature is disabled on this interface. This field can be
modified only when the interface is disabled.
References:
z Ethernet
commands
z Ethernet Stats commands.