Planet Technology IP DSLAM IDL-4801 - Manual (Page 298)

IDL series User Guide 298
GsExpandedExchange T1.413 parameter that Enables/Disables EES
GsEscapeFastRetrain This parameter enables/disables escape to the fast retrain
capability
GsFastRetrain This parameter enables/disables the fast retrain capability.
Currently supported only in G.lite mode.
GsBitSwap This parameter enables/disables bit swapping
GsNtr This parameter enables/disables NTR on a per chip basis
GsAlctlUsVer For T1.413 demo purposes only
GsUseCustomBin This parameter enables/disables user selection which of the 511
bins will be enabled for upstream and downstream transmission.
GsFullRetrain Indicates enable/disable of auto retrain capability
GsPsdMaskType This parameter selects the PSD mask option to be used
GsEraseProfiles This parameter enables/disables the ability to erase all fast retrain
profiles at startup
GsExtRsMemory Indicates whether customer's Hardware uses external RS RAM
ParamHybridLossTestStart Start bin for range of bins to be measured. The default value
mentioned is an indicative value only, for exact value refer to
document number DO-400523-AN and DO-401163-AN.
GsParamHybridLossTestEnd End bin for range of bins to be measured.
GsDmtTrellis This parameter enables/disables trellis coding. Trellis coding
should always be enabled for its clear performance advantage.
GslTriggerMode The type of event that triggers a fast retrain
Type This object is used to configure the ADSL physical line mode.
GsDnBinUsage '1' in bit position indicates usage of corresponding bin,whereas a
'0' disables usage of corresponding bin.
ParametricTestInputFile Indicates Name of the Input file from which to take the Mask Array
Size, lower and upper mask Array. Null string means no file is
specified
Data Boost Conexant parameter that enables/disables DataBoost option.
Upstream PSD Conexant parameter that sets the upstream PSD to be either
extended or standard. Used for GSpan Plus only.
Conf PM Mode PM-related parameter used by the ATU-C to set the allowed link
states. Both bit values can be given simultaneously in the input.
Additional value to disable pmmode is disable, which is equal to 0.
Conf PML0 Time(sec) PM configuration parameter, related to the L2 low power state.
This parameter represents the minimum time (in seconds)
between an exit from the L2 state and the next entry into the L2
state. It ranges from 0 to 255 seconds.
Conf PML2 Time(sec) PM configuration parameter, related to the L2 low power state.
This parameter represents the minimum time (in seconds)