Planet Technology IP DSLAM IDL-4801 - Manual (Page 167)

IP DSLAM 167
autoSupportedProtocols, its value will override.
Type: Create － Optional
Modify － Optional
Default value: none
autosensetriggertype
dynamic |
opstatechange
This field specifies at what time autodetection of Encapsulation type or
higher protocol layers is to be done - all the time or only when
Operational Status of ATM VC is changed to UP. If its value is
'dynamic', then detection can happen anytime a packet is received. If its
value is 'opstatechange', then autodetection happens only when
Operational status of ATM VC changes to UP. This field is not valid if
encaptype is Ethernet.
Type: Create － Optional
Modify － Optional
Default value: dynamic
ctlpktgroupid
ctlpktgroupid | none
The Control packet instance group associated with this VC. The flows
for this interface shall be mapped to control packet instances as
mapped for the flows corresponding to the groupid configured in ctrlpkt
group info command. If this group does not have entries for some of the
flows, then those flows shall be mapped to the ctlpktinstid of ATM port,
for which this VC is being created. If the group id is 0, then all the flows
shall be mapped to ctlpktinstid of ATM port, for which this VC is being
created.
Type: Create － Optional
Valid values: 0 -50
Default value: 0
Example:
$ create atm vc intf ifname aal5-0 lowif atm-0 vpi 10 vci 10 enable aal5 pvc
a5txsize 1536 a5rxsize 1536 llcmux mgmtmode data autosupportedprot pppoa
eoa autovcmuxforcedprot pppoa autosensetriggertype dynamic ctlpktgroupid none
Output:
Verbose Mode On
Entry Created
VC IfName : aal5-0 Low IfName : atm-0
VPI : 0 VCI : 35
Admin Status : Up Oper Status : Down
Aal5 Tx Size : 1536 Aal5 Rx Size : 1536
AAL Type : AAL5 AAL5 Encap : llcmux
channel : Interleaved Last Change(sec) : 0
MgmtMode : Data Row Status : active