Planet Technology IP DSLAM IDL-4801 - Manual (Page 164)

IDL series User Guide 164
5.5.5.4 Modify atm vc intf
Description:
Use this command to modify ATM VC parameters.
Command Syntax:
modify atm vc intf ifname <interface-name> [vpi <vpi-val>] [vci <vci-val>]
{enable | disable} [a5txsize <aal5-cpcs-tx-sdu-size>] [a5rxsize
<aal5-cpcs-rx-sdu-size>] [vcmux | llcmux | auto | ethernet] [ mgmtmode data |
mgmt | DataAndMgmt | raw] [ autosupportedprot none|{pppoa | eoa | ipoa}+]
[ autovcmuxforcedprot None | pppoa | eoa | ipoa] [ autosensetriggertype
dynamic | opstatechange ]
Parameters:
Name Description
ifname
<interface-name>
This specifies name of VC Interface.
Type: Create – Mandatory
Delete – Mandatory
Get – Optional
Modify – Mandatory
Valid values : aal5-0 - *
lowif
<atm-port-interfacenam
e>
Interface Index of the ATM port, on which this VC is getting configured.
Type: Mandatory
Valid values : atm-0 - *
vpi <vpi-val> Virtual Path Identifier. In order to modify, the VPI value shall be the new
VPI value and the admin status of VC interface shall be disabled. Also,
the VPI and VCI value cannot be modified along with admin status in
one command. If encaptype is Ethernet than value of this field has to be
0.
Type : Create – Mandatory
Modify – Optional
Valid values : 0-2^8
vci <vci-val> Virtual Circuit Identifier. In order to modify, the VCI value shall be the
new VCI value and the admin status of VC interface shall be disabled.
Also, the VPI and VCI value cannot be modified along with admin status
in one command. If encaptype is Ethernet than value of this field has to
be 0.
Type: Create – Mandatory
Modify – Optional
Valid values : 1-2^16