Planet Technology IP DSLAM IDL-4801 - Manual (Page 250)

IDL series User Guide 250
Curr Status Indicates current state of the ATUC line. This is a bit-map
of possible conditions.
Curr Snr Margin(dB/10) Noise Margin as seen by this ATU with respect to its
received signal in tenth dB.
Curr Atn(dB/10) Measured difference in the total power transmitted by the
peer ATU and the total power received by this ATU.
CurrAttainable Rate(bps) Indicates the maximum currently attainable data rate by
the ATU. This value will be equal to, or greater than the
current line rate.
Curr Output Pwr(dB/10) Measured total output power transmitted by this ATU.This
is the measurement that was reported during the last
activation sequence.
GsOpState Operational state of the Xcvr.
GsActualStandard Actual standard used for connection, based on the
outcome of the negotiation with the Remote Unit.
GsTxAtmCellCounter Provides Tx ATM cell counter.
GsRxAtmCellCounter Provides Rx ATM cell counter.
GsStartProgress Defines the current detailed start up state of Xcvr. 0x0ñ
startup not in progress; 0x0 ñ 0x0FFF
Handshake/Training/ Profile Management/ Fast Retrain
inprogress; 0x8000 ñ 0x8FFF DSP firmware DownLoad in
progress; 0xF000 ñ 0xFFFF illegal Parameter
GsIdleBertError Number of bit errors.
GsIdleBertCells Number of idle cells.
GsBertSync Indicates whether the Signal is in Sync or not.
GsBertError Provides the number of bit errors detected during BERT.
Data Boost Status Conexant parameter that indicates whether DataBoost is
utilized for the connection.
Chan Perf CD The near-end delineated total cell count performance
parameter is a count of the total number of cells passed
through the cell delineation and HEC function process,
operating on the ATM Data Path, while in the SYNC state.
(Not available for ADSL)
Chan Perf BE The near-end idle bit error count performance parameter is
a count of the number of bit errors in the idle cell payload
received in the ATM Data Path at the near-end. (Not
available for ADSL)
PM State The Line Power Management state. (Not available for
ADSL)
Chan Perf Cu The total number of data-only cells received by ATUC.