Planet Technology IP DSLAM IDL-4801 - Manual (Page 479)

IP DSLAM 479
Parameters:
Name Description
ifname
<interface-name>
The IPOE Tunneling Interface.
Type: Create － Mandatory
Delete － Mandatory
Modify － Mandatory
Get － Optional
Valid values: 0-575
lowif <lowif-val> This specifies the lower interface index.It contains the ifindex
of the IPoA interface.
Type: Create － Mandatory
Valid values: 0 － 575
macaddrprof
macaddrprof
Profile Id corresponding to the MAC address assigned to this
IPOE interface. This Profile is created using the
MacAddrProfileTable.
Type: Create － Mandatory
Modify － Optional
Valid values: 1 -8
ethpkttype Type2 |
802_3
This specifies the type of the Packet.
Type: Create － Optional
Modify － Optional
Default value: Type2
inactivitytmrintrvl
inactivitytmrintrvl
This field specifies the time (in seconds) after which
interfaces shall be marked inactive, if there is no data activity
on this interface during this interval. This is used only when
the bit corresponding to "ConfigEntry" is set for
gsvIpoeConfigStatus field. A value of zero means the timer is
not running. In autosensing scenario, an inactive interface is
a candidate to deletion, if another protocol is sensed on Atm
Vc Interface on which this interface is created
Type: Create － Optional
Modify － Optional
Valid values: 0- 0xffffffff
Default value: 0
routingstatus enable
|disable
This specifies if the IP Routing Lookup has to be done for this
interface. By default, for the downstream traffic destined for
IPOE interface, IP lookup is done based on the downstream
route configured for the IPOE interface.If iproutingstatus is
disabled, layer 2 lookup shall be used instead, for forwarding
the downstream traffic for this IPOE interface.