5 vlan mapprofile info commands, 1 get vlan mapprofile info – Planet Technology IP DSLAM IDL-4801 User Manual

Page 657

Advertising
background image

IP DSLAM

657

values; otherwise the vlan inherits the globally set

bridging mode. Unrestricted bridging is not

applicable for bridge ports created over pppoe

interface even though the vlan may be

unrestricted.For a Vlan with bridging mode as

CrossConnect there is no learning and lookup and

there are at most two member ports for it. In band

Management traffic cannot run for such a vlan.

VLAN here means the 802.1q vlan in case of

Native Vlan mode and Virtual Vlan in case of

Stacked Vlan Mode.

Flood support Status

This tells if the flooding shall be done for unknown

unicast packets for this vlan or not. The unknown

unicast packets shall be flooded to all ports for a

vlan if global value (present in Dot1dTpInfo) is

enabled or throttle and the value per vlan is also

enabled else dropped. This field is not applicable if

dot1qGsVlanFullBridgingStatus is CrossConnect

Broadcast support

Status

This tells if the broadcast shall be done for this vlan

or not. The broadcast packets shall be

broadcasted on all ports for a vlan if global value

(present in Dot1dTpInfo) and the value per vlan

are both enabled else dropped. This field is not

applicable if dot1qGsVlanFullBridgingStatus is

CrossConnect.

Reserved Mac Profile

Id

The Profile associated with this Vlan to be used to

determine the behavior for Reserved Mac destined

frames. Reserved Mac addresses are the multicast

addresses defined as reserved in IEEE 802.1Q

and IEEE 802.1ad.


5.27.5 VLAN mapprofile info Commands

5.27.5.1 Get vlan mapprofile info

Description:

Use this command to get.

Advertising
This manual is related to the following products: