Planet Technology IP DSLAM IDL-4801 - Manual (Page 656)

IDL series User Guide 656
Example:
$ get vlan curr info vlanid 45
Output:
VLAN Index : 45
VLAN Status : 1
Egress Ports : 24
Untagged Ports : 24
Bridging Mode : Residential
Flood support Status : enable
Broadcast support Status : enable
Reserved Mac Profile Id : 1
Output field:
Field Description
VLAN Index The VLAN identifier
VLAN Status This value indicates the status of the VLAN Port
corresponding to this entry. Other (1) - the entry is
for the default VLAN created for the system.
Permanent (2) - this entry, corresponding to an
entry in dot1qVlanStaticTable, is currently in use
and will remain so after the next reset of the
device. The port lists for this entry include ports
from the equivalent dot1qVlanStaticTable entry
and ports learnt dynamically. Dynamic (3) - this
entry is currently in use and will remain so until
removed by GVRP. There is no static entry for
this VLAN and it will be removed when the last port
leaves the VLAN.
Egress Ports The set of ports, which are transmitting traffic for
this VLAN, as either tagged or untagged frames.
Untagged Ports The set of ports, which are transmitting traffic for
this VLAN as untagged frames. In Stacked Vlan
mode this applies tagging/untagging for C-VLAN.
Bridging Mode This specifies the state of full bridging for the Vlan.
There can be 3 values associated with this based
on global fullBridgingStatus. These values can
be restricted bridging, unrestricted full bridging and
residential bridging. The user can specify the
bridging mode for the vlan in the
Dot1qVlanStaticTable table as one of these