Planet Technology IP DSLAM IDL-4801 User Manual

Page 664

Advertising
background image

IDL series User Guide

664

Default value: Resedential bridging

floodsupport enable | disable

This specifies if the flooding has to be done for unknown unicast

packets for this vlan or not.The default value for this shall be taken

from enable when vlan is created. The unknown unicast packets

shall be flooded on all ports for a vlan if global value (present

inDot1dTpInfo) is enabled or throttle, and the value pervlan is also

enabled else dropped.

Type: Create -- Optional

Modify -- Optional

Default value: enable

bcastsupport enable | disable

This specifies if the broadcast has to be done for this vlan or not.

The default value for this shall be taken from enable when vlan is

created. The broadcast packets shall be flooded on all ports for a

vlan if global value (present in Dot1dTpInfo) and the value per vlan

are both enabled else dropped.

Type: Create -- Optional

Modify -- Optional

Default value:enable

resvmacprofileid

<resvmacprofileid-val>

The Profile associated with this Vlan to be used to determine the

behavior for Reserved Mac destined frames. Reserved Mac

addresses are the multicast addresses defined as reserved in

IEEE 802.1Q and IEEE 802.1ad. The existence of the specified

"ResvdCtlPktProfile Table" entry is a must for VLAN static entry

creation to succeed. Further, even if the specified

"ResvdCtlPktProfile Table" entry exists, but the corresponding

entry in "ResvdCtlPktProfile Param Table" is missing the packets

will be dropped. VLAN here means the 802.1q Vlan in case of

Native Vlan mode and Virtual Vlan in case of Stacked Vlan Mode.

Type: Create -- Optional

Modify -- Optional

Valid values: 1 - 4

Default value: 1

igmpsnoopaction Drop |

TransparentlyForward | Learn

This parameter specifies that if an action is "Learn" then

igmpsnoop will be supported for this Vlan and an entry will be

learnt. Here action will be applied in conjunction with global

igmpsnoopStatus and port level igmpsnoopStatus flags, that is

IGMP functionality will be executed for a frame if IGMP is enabled

globally and on the port it has been received and for the vlan/virtual

vlan on which it has come.If action is "drop" then igmpsnoop

functionality is not supported for this vlan and IGMP frames shall

Advertising
This manual is related to the following products: