5 igmpsnoop querier info commands, 1 get igmpsnoop querier info, 2 create igmpsnoop querier info – Planet Technology IP DSLAM IDL-4801 User Manual

Page 461

Advertising
background image

IP DSLAM

461

accepted values is 00:30:4F:00:00:00 to 00:30:4F:7F:FF:FF.

Port Index

This parameter specifies a bridge port belonging to the Vlan

(igmpVlanIndex) and Group (igmpsnoopMcastAddress), for which the

IgmpSnooping statistics are desired.

Query Received

This parameter specifies thenumber of Igmp queries received on the

port belonging to a particular multicast group and Vlan.

Report Received

This parameter specifies thenumber of Membership reports received on

the port belonging to a particular multicast group and Vlan.

Filter Mode

This parameter specifies the current filter mode on a port for a given

group.

Include SrcList

This parameter specifies the Include Source list, which is the list of

sources to be included in case of Include filter mode and the list of

conflicting sources in case of exclude mode of the port for a given group

Exclude SrcList

This parameter specifies the Exclude Source list, which is the list of

sources to be excluded in case of exclude filter mode of the port for a

given group

Caution:
z

An entry in this table shall not be applicable for a bridge port created over the

PPPoE interface.

5.14.5 Igmpsnoop querier info Commands

5.14.5.1 Get igmpsnoop querier info

Description:

Use this command to get.

Command Syntax:

get igmpsnoop querier info [vlanid <vlanid-val >] [portid <portid-val>]

5.14.5.2 Create igmpsnoop querier info

Description:

Use this command to create.

Command Syntax:

create igmpsnoop querier info vlanid <vlanid-val > portid <portid-val >

Advertising
This manual is related to the following products: