Planet Technology IP DSLAM IDL-4801 - Manual (Page 162)

IDL series User Guide 162
Verbose Mode Off:
Entry Created
Output Fields:
Field Description
IfName Physical interface index
LowIfName This is the IfIndex of the low interface on which this ATM port is configured.
Lower interface can be of type 94 or 124 or 125 or 0xfffffff9
MaxVccs This specifies the maximum number of VCCs (PVCCs), supported at this
ATM interface. This field is not valid if the atmtransporttype has the value
packet
MaxConfVccs This specifies the current number of VCCs configured on this port.
MaxVpiBits The maximum number of active VPI bits configured for use at the ATM
interface.
MaxVciBits This specifies the maximum number of active VCI bits configured for use at
this ATM interface.
OAMSrc Loopback source id assigned to the ATM port. The ATM port will respond to
all loopback cells, which carry this OAM id. This field is not valid if the
atmtransporttype has the value packet.
ORL(kbps) This parameter specifies the output rate limiting value in KBPS to be applied
on this interface.
UnknownVPI This parameter specifies the last seen unknown VPI on this ATM interface.
This field is not valid if the atmtransporttype has the value packet.
UnknownVCI This parameter specifies the last seen unknown VCI on this ATM interface.
This field is not valid if the atmtransporttype has the value packet.
ProfileName This specifies the scheduling profile to be associated with the ATM port.
Current Output Rate This parameter specifies the current output rate value in KBPS that is
available on this interface, based on the minimum of DSL trained rate and
OutPut Rate limit configured for the ATM port.
trfclassprofileid This specifies the traffic class profile to be associated with the ATM port.
Ctl Pkts Instance Id This specifies the control packet instance identifier associated with this
interface. If the user does not provide any instance identifier while creating an
interface an instance is created internally from the default profile governed by
the macro 1 and associated to the interface. This will reduce the total number
to instances that can be now created by one. The default instance is
governed by macro 0.
ATM Transport Type This specifies the transport type of the atm interface. This can be either Cell
which means that actual Atm Cells shall be received over the UTOPIA
interface, or Packet , which means that Pseudo Cells corresponding to
Packet VDSL shall be received over this ATM interface. This is not modifiable