Planet Technology IP DSLAM IDL-4801 - Manual (Page 630)

IDL series User Guide 630
Parameters:
Name Description
Num-of-traps This specifies the maximum number of (entries)
traps to be displayed from trap log table; if not
specified then all entries are displayed.
Type: Optional
Valid values : 0 to 4294967295
Mode:
Super-User, User
Example:
$ get traps
Output
Thu Jan 01 00:00:13 1970 : STATUS ALARM : ATM VC Up :Interface Name–
aal5-0
Thu Jan 01 00:00:13 1970 : STATUS ALARM : System Up
Output Fields
FIELD Description
Trap time This specifies the time at which the trap was logged.
Trap severity This specifies the severity level of the trap. It can be –
CRITICAL ALARM
MAJOR ALARM
WARNING
STATUS ALARM
Trap name This specifies the name of the trap. It can be –
System Init Failed - This trap is originated at the time of system initialization
failures. The failure could be due to an internal error or due to a
wrong/corrupted configuration file. Trap parameters are Module and Cause.
System Up - This trap is originated after the unit boots up successfully.
ADSL ATUC Up - This trap indicates that the DSL port is in data mode.
ADSL ATUC Down - This trap indicates that the DSL port is no longer in data
mode.
ATM Interface Up - This trap indicates that the ATM port is operationally up.
Trap parameter is Interface No.
ATM Interface Down - This trap indicates that the ATM port is operationally
down. Trap parameter is Interface No.
ETHER Interface Up - This trap indicates that the Ethernet port is