Planet Technology IP DSLAM IDL-4801 - Manual (Page 504)

IDL series User Guide 504
Default value: Type2
nature dynamic | static Specifies if the interface is dynamic or static in nature. The session is
assumed to be in established state when the interface is static in
nature.
Type: Create － Optional
Modify － Optional
Default value: dynamic
enable | disable Administrative status of the interface.
Type: Create － Optional
Modify － Optional
Valid values: enable, disable
Default value: enable
Example:
$ create pppoe intf ifname pppoe-0 lowif ppp-0 wanbridgeport 1 sessionid 10
acmacaddr 00:30:4F:61:C1:BE macaddrprof 1 servicenameprof 2 acnameprof 4
ethpkttype Type2 nature dynamic 0x1 enable
Output:
Verbose Mode On
Entry Created
Ifname : pppoe-0 Low If Name : ppp-0
WAN Bridge Port : 1 Session Id : 10
AC Mac Addr : 00:30:4F:61:C1:BE Mac Addr Prof : 1
Service Name Profile : 2
AC Name Prof : 4
Eth Pkt Type : Type2 Nature : dynamic
Oper Status : Up Admin Status : Enable
Verbose Mode Off:
Entry Created
Output Fields
FIELD Description
Ifname The PPPoE Interface.
Low If Name This specifies the lower interface index. It contains the
ifindex of the PPP relay interface.
WAN Bridge Port WAN side bridge port. A value of zero means any WAN
side port is acceptable. Currently, only value zero is
supported.