Planet Technology IP DSLAM IDL-4801 - Manual (Page 228)

IDL series User Guide 228
Init Fail Trap Enables and disables the InitFailureTrap. This object is defaulted
disable.
OpStateTrapEnable Enables/disables the OpStateChangeTrap
PowerMgmtTrapEnable This indicates change in power mangement state
Thresh 15Min Lofs(sec) The number of Loss of Frame Seconds encountered by an ADSL
interface within any given 15 minutes performance data collection
period, which causes the SNMP agent to send an
'adslAturPerfLofsThreshTrap'
Thresh 15Min Loss(sec) The number of Loss of Signal Seconds encountered by an ADSL
interface within any given 15 minutes performance data collection
period, which causes the SNMP agent to send an
'adslAturPerfLossThreshTrap'
Thresh 15Min Lprs(sec) The number of Loss of Power Seconds encountered by an ADSL
interface within any given 15 minutes performance data collection
period, which causes the SNMP agent to send an
'adslAturPerfLprsThreshTrap'
Thresh 15Min Ess(sec) The number of Errored Seconds encountered by an ADSL
interface within any given 15 minutes performance data collection
period, which causes the SNMP agent to send an
'adslAturPerfESsThreshTrap'
Thresh Fast Rate Up(bps) Applies to 'Fast' channels only. Configured change in rate
causing an adslAturRateChangeTrap A trap is produced when:
ChanCurrTxRate > ChanPrevTxRate plus the value of this object.
Thresh Intl Rate Up(bps) Applies to 'Interleave' channels only. Configured change in rate
causing an adslAturRateChangeTrap A trap is produced when:
ChanCurrTxRate > ChanPrevTxRate plus the value of this object.
Thresh Fast Rate
Down(bps)
Applies to 'Fast' channels only. Configured change in rate
causing an adslAturRateChangeTrap A trap is produced when:
ChanCurrTxRate < ChanPrevTxRate minus the value of this
object.
Thresh Intl Rate
Down(bps)
Applies to 'Interleave' channels only. Configured change in rate
causing an adslAturRateChangeTrap A trap is produced when:
ChanCurrTxRate < ChanPrevTxRate minus the value of this
object.
References:
z ADSL
Commands