Planet Technology IP DSLAM IDL-4801 User Manual

Page 622

Advertising
background image

IDL series User Guide

622

Valid values: 1 -175

mcastcap ivmcapable

|svmcapable | none

It denotes the Multicast Device Capability. If the device

capability is ivlcapable then svmcapable is not a valid value.

If the device capability is neither ivlcapable nor svmcapable

then the only valid value for this field is none. If the device

capability is ivlcapable or svlcapable then this field can't

have value none. ivmcapable and svmcapable can't be set

together.In case of Stacked Vlan Mode this shall apply to

Virtual Vlans.

Type: Modify - Optional

ridcap irdcapable

|srdcapable

RID refers to the Routing Information Database. This

database contains information about the routes in the

system. Each RID identifies a flow and defines route related

information for that flow. The RID defines a flow based on

the VLAN Id. The database can be of 2 types,

IRD( Independent Routing Database) where there are more

than one RIDs in the system and each RID defines separate

routes in context of itself. If VlanId <X> and RID <X> have

been created and the routing database is configured for

IRD, than routes in RID <X> shall define flow for packets

coming on VLAN Id <X>. The other mode for the database

is SRD( Shared Routing Database) where there is a single

RID in the system and all flows map to this RID. This RID

has to be explicitly created and no more than 1 RID can be

created in the system in this mode. Flows for all created

VLANs shall map to this RID for routing.

Type: Modify - Optional

maxnumac

<maxnumac-val>

It denotes the maximum number of Access Concentrators

supported.

Type: Modify - Optional

Valid values: 1 - 8

maxnumsrcmac

<maxnumsrcmac-val>

It denotes the maximum number of Source MAC addresses

that can be used across the different PPPOE and IPOE

interfaces.

Type: Modify - Optional

Valid values: 1 - 8

vlanmode nativemode

|stackedmode

Vlan Mode Type: Modify Optional

svlanprotocolid

<svlanprotocolid-val>

This specifies the ProtocolId value to be used for Stacked

Vlan/Service Vlan/Provider Vlan/Second Vlan tag. It is

Advertising
This manual is related to the following products: