Planet Technology IP DSLAM IDL-4801 - Manual (Page 705)

IP DSLAM 705
Enabling Multiple Hosts
You can enable a specific port to allow multiple users. When a port is enabled for
multiple users, and a host that is connected to that port is authorized successfully,
any host (with any MAC address) is allowed to send and receive traffic on that port.
If you connect multiple hosts to that port through a hub, you can reduce the
security level on that port.
To enable access for multiple users on a specific port, perform this task in
privileged mode:
Task Command
Enable multiple hosts on a specific port. create port dot1x mod/port multiple-host enable
Disabling Multiple Hosts
You must disable access for multiple users on any port where it is enabled.
To disable access for multiple users on a specific port, perform this task in
privileged mode:
Task Command
Disable multiple hosts on a specific port. create port dot1x mod/port multiple-host disable
802.1X Protocol over IP DSLAM
In 802.1x application, the IP DSLAM acts as the pure Ethernet packets transport
system. The 802.1x packets pass through the IP DSLAM without further operation
(see below figure)