Planet Technology IP DSLAM IDL-4801 - Manual (Page 475)

IP DSLAM 475
can be added in the downstream direction for the IPOE interfaces
(gsvIpRouteIfIndex as ipoe-*). The next hop in such cases has to be
same as the destination IP address (gsvIpRouteDest) specified.
Ifname The index value which uniquely identifies the local interface through
which the next hop of this route should be reached. If IpRouteRid is
not GS_CFG_MGMT_RID, than u32IpRouteIfIndex shall be
mandatory to be specified in the "create ip route" command. The
ifname value can be either ANYWAN or ifindex of any of the ipoe
interface (ipoe-*).
Route Type The type of route. It may be: dir (for Direct) or ind (for Indirect).
Route Orig The routing mechanism, through which this route was learned. It
may be: NET (for Network Management), LCL (for Local), RIP,
ICMP,DYI (Dynamic through Interface creation).
Age The number of seconds since this route was last updated or
otherwise determined to be correct.
ProxyArpStatus This specifies if the Proxy ARP has to be done for this iproute
table entry.If IpRouteRid value is 0, then ProxyArpStatus will not be
specified while creating/modifying an entry in IpRoute Table.
References:
z get ip route command
z delete ip route command
z arp related commands.
5.16.3 Ipoa intf Commands
5.16.3.1 Get ipoa intf
Description:
Use this command to get.
Command Syntax:
get ipoa intf [ifname <interface-name>]
5.16.3.2 Create ipoa intf
Description:
Use this command to create.