Planet Technology IP DSLAM IDL-4801 - Manual (Page 193)

IP DSLAM 193
5.6.9.4 Modify bridge static ucast
Description:
Use this command to modify.
Command Syntax:
modify bridge static ucast vlanid <vlanid-val> ucastaddr <ucastaddr-val>
[portid <portid-val>]
Parameters:
Name Description
vlanid <vlanid-val> The VLAN index referring to this VLAN. In case of device
capability not supporting vlans, vlan id "0" is a valid value.
VLAN here means the 802.1q Vlan in case of Native Vlan mode
and Virtual Vlan in case of Stacked Vlan Mode.
Type: Create － Mandatory
Delete － Mandatory
Modify － Mandatory
Get － Optional
Valid values: 0 - 4095
ucastaddr
<ucastaddr-val>
The destination unicast MacAddr to which filtering info applies.
Type: Create － Mandatory
Delete － Mandatory
Modify － Mandatory
Get － Optional
portid <portid-val> The set of ports, for which a frame with a specific unicast
address will be flooded in the event that it has not been
learned. It also specifies the set of ports a specific unicast
address may be dynamically learnt on. This list shall have only
the CPE side ports. Currently only one port can be set in this
list. Type: Create － Optional
Modify － Optional
Valid values:1-386
Example:
$create bridge static ucast vlanid 1 ucastaddr 1:1:1:1:1:1 recvport 0 portid 2 status
1 cfgmode Config