Planet Technology IP DSLAM IDL-4801 - Manual (Page 254)

IDL series User Guide 254
5.9.9 ADSL ATUC Trap Commands
5.9.9.1 Get adsl atuc traps
Description:
This command is used to get.
Command Syntax:
get adsl atuc traps [ifname <interface-name>
Example:
$ get adsl atuc traps ifname dsl-0
Output:
Ifname : dsl-0
Lofs Thresh Trap : 0 Loss Thresh Trap : 1
Lols Thresh Trap : 0 Lprs Thresh Trap : 1
ESs Thresh Trap : 1 Init Failure Trap : 1
Rate Change Trap : 0 Gs OpState Trap : 1
PM State Trap : 2 Command Failure Trap : 2
Output Fields :
FIELD Description
Ifname The IfIndex of DSL port.
Lofs Thresh Trap Loss of Framing 15-minute interval threshold reached (length = 4 bytes).
Loss Thresh Trap Loss of Signal 15-minute interval threshold reached (length = 4 bytes).
Lols Thresh Trap Loss of Link 15-minute interval threshold reached (length = 4 bytes).
Lprs Thresh Trap Loss of Power 15-minute interval threshold reached (length = 4 bytes).
ESs Thresh Trap Errored Second 15-minute interval threshold reached (length = 4 bytes).
Init Failure Trap ATU-C initialization failed. Refer to adslAtucCurrStatus for potential reasons
(length = 4 bytes).
Rate Change Trap The ATU-Cs transmit rate has changed (RADSL mode only) (length = 4 bytes).
Gs OpState Trap Op State change (length = 4 bytes).
PM State Trap PM state change trap used for ADSL2/ADSL2plus PM operation. This trap is not
valid for ADSL mode.
Command Failure Trap When the APIs fail to send a customer command to the DSP, the customer is
notified by a new trap and they need to re-issue the command.