Planet Technology IP DSLAM IDL-4801 - Manual (Page 362)

IDL series User Guide 362
5.13.13.2 Modify clfr tree node
Description:
Use this command to get.
Command Syntax:
modify clfr tree node tname <tname-val>pid <pid-val>nodeid <nodeid-val>
[ descr <descry-val> ] [ offset <offset-val> ] [ mask <mask-val> ] [ value
<value-val> ] [act Drop|Fwd|FwdToCtl|CpToCtl|Eq|Gt|Lt|InRange |TerCmp|
SetPrio|MatchInList|AccDeny|SetBase|Count| Retagprio |
MatchIngenlist|GoToNextRule| allow] [valend valend ] [sbasetype Abs | Add |
Compute] [ shiftcnt <shiftcnt-val> ] [ mplr <mplr-val> ] [valtype
U8|U16|U32|U64|AtmIf|Aal5Vc|EoaIf|EthIf|Dir|Prio|Len|vlanid][ sbvarindex
l2start|l3start ] [nodeprio low]
Parameter:
Name Description
tname tname Name of the classifier tree
Type: Modify -- Mandatory
Get -- Optional
Default value: -----
pid pid Profile Id. It should be unique within a tree.
Type: Modify -- Mandatory
Get -- Optional
Valid values: 1 - 0xffffffff
Default value: -----
nodeid nodeid Node Id, should be unique within a profile
Type: Modify -- Mandatory
Get -- Optional
Valid values: 1 - 0xffffffff
Default value: -----
descr descr Description of the tree node. If the ActVal is FwdToCtl or CpToCtl
then this field is mandatory and it can be used by the applications to
receive the packets coming from control plane because of this node.
Type: Modify -- Optional
Default value: -----
offset offset OffSet, in the packet with respect to the base offset, from where we
have to take the value, which is to be matched. If ActVal is SetBase
and SBaseType is Compute then this value is used to specify the
offset with respect to the base offset, which shall be used to specify
the field of the packet used to compute the new base offset. If the