Planet Technology IP DSLAM IDL-4801 - Manual (Page 429)

IP DSLAM 429
IGMP type comparison IGMP type comparison type
Igmp code This field specifies the Max Response Code (time) fields of
IGMP packet. This field is invalid if igmphCodeCmpType is
any.
IGMP code comparison IGMP code comparison type
Start group address Start group address of the range of igmp group addresses.This
field is invalid if 'igmpgroupaddrcmp' is 'any'. This field and
'groupaddrto' specify a range of IGMP group addresses, if
'igmpgroupaddrcmp' is either 'inrange' or 'exrange'
End group address End group address of the range of igmp group addresses. This
field and 'groupaddrfrom' specifiy a range of IGMP group
addresses, if 'igmpgroupaddrcmp' is either 'inrange' or 'exrange'
IGMP group address
comparison
IGMP group address comparison type
Subrule Priority This specifies the priority of the subrule. Based on this priority
value, the subrule is created in fast or slow memory. In case
priority is specified as 'asinrule', subrule priority will be same as
specified in the rule.
Transport Header This specifies the type of the transport header in the packet in
which the corresponding IP is being transported. If the value of
this field is Ethernet(0x1), then the IP is being carried in the
ethernet header. If it is pppoe(0x2), then the corresponding IP is
being carried in the PPP header.
References:
z
Generic Filter commands
5.13.32 Filter subrule IP Commands
5.13.32.1 Get Filter subrule ip
Description:
Use this command to get.
Command Syntax:
get filter subrule ip [ruleid <ruleid-val>] [subruleid <subruleid-val >]