Planet Technology IP DSLAM IDL-4801 - Manual (Page 450)

IDL series User Guide 450
Output:
Query Interval : 12 Query Response Interval : 10
StartUp Query Interval : 10 UnSolicRprtInterval : 10
Anxious Timer : 125 V1 Host Timer : 130
Last Member Query Interval : 125 Robustness Variable : 2
Igmp Snoop Status : Enable
Version Mask : v3
Report Suppression Status : Enable Proxy Report Status : Enable
StartUp QryCount : 2 Last Member QryCount : 100
Output field:
Field Description
Query Interval This parameter is used to calculate the entry age out timer, when
no reports or queries are received on the entry. When the value
of this parameter multiplied by 10, it should be greater than the
Query Interval configured at the router. The time for which an
entry created at Igmpsnoop module exists, if no messages are
received for it is approximately
(((QueryInterval*10)*Robustness) + Query Response Time
received in Last Query)
Query Response
Interval
This parameter is used to derive Max Response Code to be filled
in General query that will be initiated from Columbia
StartUp Query Interval This parameter specifies the interval between General Queries
sent on receiving Port Up topology change trigger.
UnSolicRprtInterval This parameter specifies the interval between unsolicited
membership reports of a group sent for robustness no of
times.This field is applicable only when proxy reporting is
enabled.
Anxious Timer This parameter specifies the maximum time (in seconds) before
which the IgmpSnoop module will forward all IGMP membership
reports received. It is started once, whenever the first
membership report is received for a group, to ensure that reports
are forwarded for a sufficiently long time, to take care of any lost
reports. The unit is seconds.
V1 Host Timer This parameter specifies the maximum time (in seconds), for
which the IgmpSnooping module can assume that there are
Version 1 group members present, for the group for which this
timer is running. The unit of this parameter is seconds.
Last Member Query
Interval
This parameter specifies the Last Member Query Interval that is
the Max Response Time inserted into Group-Specific Queries