Solare Datensysteme Solar-Log - Manual (Page 145)

145
Kstar
Kstar Singletracker
Connect the inverters to each other
•
Connect using a network cable (patch cable) ( No Crossover cable)
•
Where to connect: RJ45 sockets on the outside of the inverter.
Procedure
1. Insert the RJ45 plug into the free RJ45 socket on the first inverter.
2. Insert the other end of the wire into any RJ45 socket on inverter 2.
3. Connect the other inverters to each other in the same way.
4. Terminate in the last inverter, set the DIP switch to “on.”
Allocate communication address
•
Recommendation: Continuous numbering from 1 to 254
•
Setting: Using the inverter operating display.
•
Procedure: Start according to the inverter’s instructions.