Solare Datensysteme Solar-Log - Manual (Page 152)

152
Mitsubishi
Mitsubishi with RS485 interface
Procedure
1. Unscrew the front plate of the inverter as shown in the inverter's instructions.
2. Insert the RJ1plug into any RJ11 socket on inverter 1.
3. Insert the other end of the cable into any RJ11 socket on inverter 2.
4. Connect the other inverters to each other in the same way.
5. Terminate in the last inverter.
Set the DIP switch for the terminal resistor to ON.
6. Screw the inverter front plate on again.
Allocate communication address
•
Recommendation: Continuous numbering starting with 1.
•
Setting: Using the inverter operating display
•
Procedure: Start according to the inverter's instructions