Solare Datensysteme Solar-Log - Manual (Page 69)

69
CyberPower
CyberPower
Connect the inverters to each other
•
Connect using a network cable (patch cable).
•
Where to connect: RJ45 socket on the outside of the inverter.
Procedure
1. Insert the RJ45 plug in inverter 1 into the RJ45 socket.
2. Insert the other end of the wire into the other RJ45 socket on inverter 2.
3. Connect the other inverters to each other in the same way.
4. Insert the terminal block connector into the Solar-Log™ RS485 socket.
5. Terminate in the last inverter according to the inverter instructions.
Allocate communication address
•
Recommendation: Continuous numbering starting with 1.
•
Address range: 1 - 247
•
Setting: Using the inverter operating display
•
Procedure: Start according to the inverter's instructions