Lenze E84DSxxx - Manual (Page 229)

Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
229
6 I/O terminals
6.4 User-defined terminal assignment
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.4.2 Changing the terminal assignment with the keypad
You can reconfigure the preconfigured terminal assignment with the keypad (and with the
»Engineer«) by means of so-called configuration parameters.
• Each configuration parameter represents a signal input of a system block or application block.
• Each configuration parameter contains a selection list with output signals of the same type of
data.
• Logical linking is thus carried out by selecting the output signal for the corresponding signal
input.
In the following example, digital output 1 (LS_DigitalOutput.bOut1 input) is logically linked to the
status signal "Drive ready" (LA_nCtrl_bDriveReady output signal):
Configuration parameters for the digital output terminals
The subcodes of
C00621 serve to change the preconfigured terminal assignment of the digital
output terminals:
Other subcodes (not shown here) allow the configuration of input signals of different system blocks
and port blocks.
Parameter Info Lenze setting
Value Unit
Digital outputs - terminal assignment
C00621/2 LS_DigitalOutput:bOut1 1000: LA_nCtrl_bDriveReady
C00621/99 LS_DigitalOutput: bOut2 0: Not connected