Lenze E84DSxxx - Manual (Page 502)

15 Parameter reference
15.2 Parameter list | C00148
502
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00148
Parameter | Name:
C00148 | Config. group error
Data type: UNSIGNED_16
Index: 24427
d
= 5F6B
h
From version 02.00.00
Selection of the device statuses for which the bCollectedFail group error output of SB LS_DriveInterface is to be set
to TRUE.
Setting range
(min. hex value | max. hex value) Lenze setting
0x0000 0xFFFF 0x0030 (decimal: 48)
Value is bit-coded: ( = bit set) Info
Bit 0  SafeTorqueOff
Bit 1  ReadyToSwitchOn
Bit 2  SwitchedOn
Bit 3  TroubleQSP
From version 06.00.00
Bit 4  Trouble
Bit 5  Fault
Bit 6  Warning
Bit 7  ImpIsActive
Bit 8  CInhIsActive
Bit 9  Fail CAN_Management
Bit 10  Reserved
Bit 11  Reserved
Bit 12  Reserved
Bit 13  Reserved
Bit 14  Reserved
Bit 15  Use 16BitFailNo.
From version 06.00.00
If this bit is set, the short 16-bit error number
(wStateDetermFailNoShort) is also provided at the
wStateDetermFailNoLow output of the
SB LS_DriveInterface .
• In this case, the wStateDetermFailNoHigh output is
"0".
• Advantage: The bus transfer of the error numbers is
possible via a data word without changing the
interconnection of the technology application.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT