Lenze E84DSxxx - Manual (Page 304)

8 Basic drive functions (MCK)
8.3 Speed follower
304
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.3 Speed follower
The 8400 protec StateLine controller only supports the "Speed follower" operating mode, in which
the drive follows a speed setpoint.
8.3.1 Parameter setting
Short overview of parameters for the "speed follower" operating mode:
In the »Engineer», you can set the initial limit by means of the dialog box Min/Max speed.
• Open the Min/max speed dialog box by opening the Application Parameters tab and clicking on
the following button on the dialog level Overview  Signal flow:
Parameter Info Lenze setting
Value Unit
C02610/2 MCK: Ramp time synchr. setpoint 2.000 s
C02611/1 MCK: Pos. max. speed 199.99 %
C02611/2 MCK: Pos. min. speed 0.00 %
C02611/3 MCK: Neg. min. speed 0.00 %
C02611/4 MCK: Neg. max. speed 199.99 %