Lenze E84DSxxx - Manual (Page 636)

15 Parameter reference
15.2 Parameter list | C02607
636
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02607
C02610
Parameter | Name:
C02607 | Holding brake: Status
Data type: UNSIGNED_16
Index: 21968
d
= 55D0
h
Switching status of the holding brake control
 Holding brake control
Display area (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Brake applied Holding brake is completely applied
Bit 1 Brake released Holding brake is completely released
Bit 2 Feedforward control active Feedforward control for holding of the load via the motor
is active before the holding brake releases.
Bit 3 Closing active The brake closing time ( C02589/1 ) expires
Bit 4 Forced release active In case of automatic operation of the holding brake
control, the brake is directly released via the MCK input
bBrkRelease = TRUE
Bit 5 Release active The brake release time ( C02589/2 ) expires
Bit 6 Setpoint synchronisation active A speed setpoint at the MCK is approached along a
defined ramp after brake release
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C02610 | MCK: Accel./decel. times
Data type: UNSIGNED_32
Index: 21965
d
= 55CD
h
Ramp times for speed setpoint synchronisation
Setting range
(min. value | unit | max. value)
0.000 s 999.999
Subcodes Lenze setting Info
C02610/1 2.000 s MCK: Holding brake ramp time synchr.
• Ramp time for approaching the speed setpoint at the
MCK after holding brake release.
 Holding brake control
C02610/2 2.000 s MCK: Ramp time synchr. setpoint
• Time for synchronisation ramps between setpoint
jumps occurring through the exceedance of
minimum and maximum speed setpoint limit ranges.
C02610/3 2.000 s MCK: SM stopping ramp
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000