Lenze E84DSxxx - Manual (Page 578)

15 Parameter reference
15.2 Parameter list | C00632
578
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00632
C00633
C00622/12 0: Not connected LP_MciOut : dnOut34_p
C00622/13 0: Not connected LS_DigitalInput : dnPosIn12_Set_p
C00622/14 0: Not connected Reserved
C00622/15 0: Not connected Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00622 | System connection list: Angle
Data type: UNSIGNED_16
Index: 23953
d
= 5D91
h
Parameter | Name:
C00632 | L_NSet_1: Max.SkipFrq.
Data type: INTEGER_16
Index: 23943
d
= 5D87
h
Maximum limit values for the speed blocking zones
• Selection of the maximum limit values for the blocking zones in which the speed must not be constant.
Setting range (min. value | unit | max. value)
0.00 % 199.99
Subcodes Lenze setting Info
C00632/1 0.00 % L_NSet_1 : Blocking speed1 max
C00632/2 0.00 % L_NSet_1 : Blocking speed2 max
C00632/3 0.00 % L_NSet_1 : Blocking speed3 max
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00633 | L_NSet_1: Min.SkipFrq.
Data type: INTEGER_16
Index: 23942
d
= 5D86
h
Minimum limit values for the speed blocking zones
• Selection of the minimum limit values for the blocking zones in which the speed must not be constant.
Setting range (min. value | unit | max. value)
0.00 % 199.99
Subcodes Lenze setting Info
C00633/1 0.00 % L_NSet_1 : Blocking speed1 min
C00633/2 0.00 % L_NSet_1 : Blocking speed2 min
C00633/3 0.00 % L_NSet_1 : Blocking speed3 min
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100