Lenze E84DSxxx - Manual (Page 332)

9 Diagnostics & error management
9.5 Drive diagnostics via keypad/bus system
332
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.5 Drive diagnostics via keypad/bus system
Keypad display of the controller status
• If the diagnosis terminal is connected to the diagnostic
interface X70, the status of the controller is shown via
different icons on the LCD display in the area .
Icon Meaning Note
 Controller is switched on.  SwitchedOn ( 85)
 Controller is enabled.
 Application in the controller is stopped.
 Quick stop active
 Controller is inhibited. The power outputs are inhibited.
 Controller is ready to start.  ReadyToSwitchOn ( 84)
 Speed controller 1 at the limit. The drive is torque-controlled.
 Set current limit has been exceeded in motor
or generator mode.
 Pulse inhibit active The power outputs are inhibited.
 System fault active
 Fault  Fault ( 89)
 Trouble  Trouble ( 88)
 TroubleQSP  TroubleQSP ( 87)
 Warning active