Lenze E84DSxxx - Manual (Page 630)

15 Parameter reference
15.2 Parameter list | C01124
630
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01124
C01138
C01139
Parameter | Name:
C01124 | Sync correction width
Data type: UNSIGNED_8
Index: 23451
d
= 5B9B
h
Correction increment for device synchronisation
• If the cycle times of the synchronisation signal differs and phase-locken loop (PLL) differ from each other, this
setting defines the measure the phase-locking loop is reset with.
• If synchronisation is not reached, select a higher correction constant.
• The optimum setting depends on quartz precision and must be determined empirically if required.
Selection list (Lenze setting printed in bold)
1 100ns
2 200ns
3 300ns
4 400ns
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01138 | L_Transient 1-4: Function
Data type: UNSIGNED_8
Index: 23437
d
= 5B8D
h
Selection of edge evaluation
Selection list
0 High edge
1 Low edge
2 High and low edge
Subcodes Lenze setting Info
C01138/1 0: High edge L_Transient_1 : Function
C01138/2 0: High edge L_Transient_2 : Function
C01138/3 0: High edge L_Transient_3 : Function
C01138/4 0: High edge L_Transient_4 : Function
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01139 | L_Transient 1-4: Pulse duration
Data type: UNSIGNED_16
Index: 23436
d
= 5B8C
h
Setting range (min. value | unit | max. value)
0.000 s 60.000
Subcodes Lenze setting Info
C01139/1 0.000 s L_Transient_1 : Pulse duration
C01139/2 0.000 s L_Transient_2 : Pulse duration
C01139/3 0.000 s L_Transient_3 : Pulse duration
C01139/4 0.000 s L_Transient_4 : Pulse duration
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000